ZZ-608 Bearing Flange
by johnpanter, published
Tired of messing about with large washers on each side of your T2 belt idler bearings, to keep the belt in line? Use two of these things to flange-up your ZZ-608 bearings.
Seem to print best at 0.2mm layer thickness. I used no infill to keep them solid.
Drop the flanges in hot water for a minute; a quick dry and they slip on your ZZ-608 bearing like a glove. I use them just as is, but you couldplace a drop of super-glue on the join , between the two flanges if you are a worrier. Enjoy my thingy