They Like It
Wire Harness Shield by builttospec is licensed under the Attribution - Share Alike - Creative Commons license.
© 2009 by builttospec
Instructions
All parts are cut from 1/8" clear acrylic and I used 3/8" #6 screws to fasten the clamps down.
TIP: You'll likely need to clean out the holes for the 0.1" headers with a needle or a push pin, as the small cylinder of acrylic left from cutting the holes will likely get stuck in them. Alternatively, you can also go over the holes twice when you cut out the shield. This worked well for me and can easily be done by copy/pasting another set of holes on top of the existing ones.
You may have noticed in the pictures that one of the wire clamps is a bit longer than the other. This was one of the clamps I was using when I made my first prototype and I wanted to see if I could make the clamps spring loaded (the edges hung over the edge so you could easily pull the clamp up). I found that it was easy to do so with some simple hardware, but it didn't work very well (mainly because it was hard to remove jumper wires). I'd really like to find a way to simply fold the clamps over the wires from the outside and lock them in place...
