Colbeagle
20
Likes
793
Downloads
2671
Views
Published on June 11, 2011
This thing was Featured on June 11, 2011
Derived from
The head of Stephen Colbert
by Colbert
Description
As seen on TV!
Instructions
Just a little bit of glue and it can be yours.
You must be logged in to post a comment.
License
More from JonMonaghan
Very nice. The head was printed on my Cupcake with Gen4 and Mk6+, the wings were printed on the standard T-O-M, and the base was printed on the the Reprap with Gen4 and Mk6+. I then swapped the wings and base printers for the opposite color scheme. Total plastic weight is 0.46 lbs for the model at 15% infill making it cost about $10 per model.