Filament Spool Screwless Stacker
13
Likes
398
Downloads
300
Views
Published on June 11, 2011
Derived from
Filament Spool Stacker
by tbuser
Description
Derivative of Tbuser's filament spool stacker modified to have charles pax's filament spool pre-attached so you don't have to screw it on. Just snap them into place and put the spool on.
Challenges his use of screws... Seriously? 4 screws to add a filament spool? To much work for me...
Instructions
Print with support material. The short side should be printed on the bottom to conserve material.
You must be logged in to post a comment.
License
Filament Spool Screwless Stacker by Linkreincarnate is licensed under the Attribution - Share Alike - Creative Commons license.
More from Linkreincarnate
Great idea, so you'd print one regular holder to mount it on the MakerBot and then these can just snap right in. One problem though, it's 124mm tall. My setup only goes to a little over 119. You might also need a little extra room between the base of the snap on part if you use spool housings on your spools.
So I just need to take like 5 or 6 mm of the height then? No problem I'll upload it in a sec.