Downloads
They Like It
HPI Savage-X camera mount by Neophyte is licensed under the Attribution - Share Alike - Creative Commons license.
© 2011 by Neophyte
Instructions
Remove the front upper bumper/bull-bar assembly and remove the dummy spot-lights. Fit the "hpi bumper mount" in place of the spot lights using two M3 bolts and nuts (preferably nylock nuts).
The "pen socket" is to be fitted upright "over" the bumper mount with a M3 x 16mm bolt and nut. On the front-inside of the "pen socket" are two recesses for M3 nuts. This might be a little tricky to fit and keep in place. These nuts are for the two M3 x 16mm bolts that hold the "pen socket" over the upper bar of the bull-bar. You might have to use two washers on each bolt to help prevent them from protruding into the pen socket and touching the pen's body.
Insert the pen cam and use a M3 bolt and nut at the top of the socket to pinch the socket a bit to secure the pen cam from popping out whn "driving" the monster truck over rough terrain. Adjust the pen cam's angle to your liking and tighten all bolts.