Loading

Filament extruder based on LYMAN's version

by Marcella, published

Filament extruder based on LYMAN's version by Marcella May 26, 2013

Description

This is my version of a filament extruder, to recycle and make cheap filament. I did it based on LYMAN manual and one that TIM ELMORE did IT.

youtube.com/watch?v=Z3FihRdwaQQ

Recent Comments

view all

What are your recommendations for modifying this assembly to extrude a narrow sheet (~1.5" wide, 1mm thick), instead of a filament. Looking for recommendation on die

where did bought the motor ?
or can you tell me how I look for it ??

Hello, what motor and gearbox are you using? Thanks

More from 3D Printer Extruders

view more

Comments

You must be logged in to post a comment.

pclauinger on Feb 14, 2014 said:

What are your recommendations for modifying this assembly to extrude a narrow sheet (~1.5" wide, 1mm thick), instead of a filament. Looking for recommendation on die

Rookie on Aug 1, 2013 said:

where did bought the motor ?
or can you tell me how I look for it ??

monra_86 on Jul 16, 2013 said:

Hello, what motor and gearbox are you using? Thanks

Tesseract on Jun 11, 2013 said:

Also what temp display unit are you using

Tesseract on Jun 11, 2013 said:

HI congrats on you extruder I am doing almost the exact same thing I will be using a NEMA 23 gearmotor and was wondering about the size of your motor assembly is it something like a standard NEMA stepper motor with a gearbox on it? That has been my biggest stumbling block actually deciding on the motor I think I have one but would love to hear more about what you came up with on yours. other than the motor assembly are two systems will look amazingly similar.

Thanks for your time.

gizmo on May 26, 2013 said:

Hello,

good job !

What is the ref part of motoreductor ?
Which is extrusion speed?

Top