Hybrid iPad/iPhone dock
72
Likes
1262
Downloads
2179
Views
Published on June 19, 2011
This thing was Featured on June 20, 2011
Derived from
iPhone Dock
by Zaggo
Description
This device is a versatile dock for charging your iOS devices. iPads won't tip it over, and iPhones fit perfectly. Your 30-pin cable will be held in place by the channel in the bottom, an idea I brutally stole from Zaggo's iPhone dock. His thing is totally awesome, but it wouldn't fit my iPad as well, which is why I created this. The model was created in modo, and I've attached the original .lxo file.
Instructions
I recommend printing this thing with a high amount of infill to make it weigh more. This picture from Zaggo's dock shows how best to get the cable in: thingiverse.com/image:6503
You must be logged in to post a comment.
zeke7237
on
March 3, 2012
said:
I like the design and printed one .. only thing I don't like is the angle at which it supports the ipad. If I can figure out how to get the lxo into something I know how to use I might try and change it a bit to maybe make it lean back 5-10 degrees more than current.
UechiMike
on
January 17, 2012
said:
Needed to be modified slightly to fit the cable in. Also had a little curling around the edges (30% infill w/ 1 shell). Kapton HPB. Might re-design - but works well enough.
More from Pointedstick
More from Gadgets
It works! I had some problems with the front edge delaminating. That is not a knock on your design, it was me still learning how to level the platform.