Motorcycle Stand Wall Mount
by DanLuc, published
The motorcycle stand was always in the way no matter where I stored it. And since we all play in the world of 3D up it went on the wall.
Liked Byview all
Give a Shout Out
I didn't print it 100% solid and i overtighten one of the 4 screwws and sure enough it cracked a little. Didn't seem to affect it, but only time will tell I guess.
I did pull on the hook with way more weight then the stand so I think it will stand the test of time? HA! if that doesn't make you want to print it I don't know what will lol.
The diameter of the stand is roughly 33mm and I made the ID on the hook 35mm. Gave it some support on the base and looks great actually.
My stand is heavvier on one side hence the offset, but one hook should be enough.