Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
Sandpaper Holder (Round front with slide on clips)
by M_G, published
1
Share
1792
296
Report Thing as Inappropriate
Description
A modification of 4ndy's Sandpaper holder to fit 5cm wide strips of sandpaper that are lying around in the lab here. The curved front is useful for sanding certain shapes that 4ndy's original flat fronted version might not have been suitable for. Also, rather than use a nut and bolt to tie the 2 halves together I have opted for printed clips that slide over the join between the 2 sides to wedge the sandpaper into place. To attach the clips to each other you can drill out the cone shaped drill guides to 2.8mm diameter on one side and 3mm diameter on the other and glue some offcuts of 3mm filament into the smaller holes to make a peg that will snugly fit into the slightly larger hole.
1792
296
Report Thing as Inappropriate
Makes
Remixed From
Tags
License
Sandpaper Holder (Round front with slide on clips) by M_G is licensed under the Public Domain license.
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.
Print Thing Tag
Instructions
1. Print
2. Clean up any parts and remove raft if applicable
3. Drill out the cone shaped drill guides to 2.8mm diameter on one side and 3mm diameter on the other, making them about 5-10mm deep
4. Glue some short offcuts (10-20mm long) of 3mm filament into the smaller (2.8mm diameter) holes to make a peg that will snugly fit into the slightly larger (3mm diameter) hole.
5. Wrap sandpaper around tool, inserting cut ends into gap
6. Press on clips from both sides until the pegs and holes mate
7. sand your curved object with ease!
2. Clean up any parts and remove raft if applicable
3. Drill out the cone shaped drill guides to 2.8mm diameter on one side and 3mm diameter on the other, making them about 5-10mm deep
4. Glue some short offcuts (10-20mm long) of 3mm filament into the smaller (2.8mm diameter) holes to make a peg that will snugly fit into the slightly larger (3mm diameter) hole.
5. Wrap sandpaper around tool, inserting cut ends into gap
6. Press on clips from both sides until the pegs and holes mate
7. sand your curved object with ease!
Sandpaper Holder (Round front with slide on clips) by M_G is licensed under the Public Domain license.
Download All Files
(51 kb zip file)
Comments
You must be logged in to post a comment.
