fanholder for the ultimaker (yet another)
by Berserker, published
Description
it can hold two fans (50mm * 50mm).
The lights are still from that big warehouse that uses the colors blue and yellow, for more information ikea.com/nl/nl/catalog/products/00191735.
Recent Comments
view all
Hello Flugal,
in the comment below, 'Letusgo2Hell' correctly states that this design gives problems with the endstops. t make it smaller, I'd remove the front led holder. I think that i could change the design to support 2 60mm fans, bus then the problems with the endstops will be back. :-[
Sorry,
Karijn
can you make 1 for 60 mm fan's ?? i would love to see that happening
Hai Letusgo2hell(aptly named),
I noticed that the fan holder is a little big, so removed the front part. In my (1st) version, I didn't use the end stops at all.
Tags
License
Give a Shout Out
Instructions
- mount
Comments
You must be logged in to post a comment.
Hi Berserker!
This fanholder does not fir to the latest Ultimaker version.
There are problems with the x and y end stops!!! It is possible that anyone could destroy the printer.
Ciao, Marco
Hai Letusgo2hell(aptly named),
I noticed that the fan holder is a little big, so removed the front part. In my (1st) version, I didn't use the end stops at all.
can you make 1 for 60 mm fan's ?? i would love to see that happening
Hello Flugal,
in the comment below, 'Letusgo2Hell' correctly states that this design gives problems with the endstops. t make it smaller, I'd remove the front led holder. I think that i could change the design to support 2 60mm fans, bus then the problems with the endstops will be back. :-[
Sorry,
Karijn