Laser cut Meta-Brick

Metabrick-animal

Description

This is the final design that evolved out of my lasercut snapping connector tests I did here: thingiverse.com/thing:942

Instructions

These are designed to be cut out of a 2mm sheet of Delrin but you can try with any 2mm sheet. Acrylic will not work because it breaks too easily.

Correction: I earlier wrote that I cut it out from HDPE but this was a mistake I mixed it up it was actually Delrin.

Other People's Variations

by noahbedford

Discussion

Downloads

pe circlesnap3.dxf 29 kb / 217 downloads

download

pe circlesnap3 2eck.dxf 28 kb / 203 downloads

download

pe circlesnap3 4eck.dxf 30 kb / 204 downloads

download

pe circlesnap3 5eck.dxf 29 kb / 214 downloads

download