LaserBeamTarget
by BodgeItQuick, published
1184
161
Report Thing as Inappropriate
Description
Laser beam Target to fit a Universal M300 laser to align the laser beam.
The Laser I have is an old > 10 years used laser cutter The problem seen was push fit bearing holes were not straight so bearings did not fit vertical to the board surface see pic of single bearing.
I noticed that the Lense assembly had a secondary counter bore around the laser hole made a target to fit the counter bore to alow laser alignment using the red spot laser / Lid open mode.
Push fit bearings now sit parallel after laser adjustment using the target
The Laser I have is an old > 10 years used laser cutter The problem seen was push fit bearing holes were not straight so bearings did not fit vertical to the board surface see pic of single bearing.
I noticed that the Lense assembly had a secondary counter bore around the laser hole made a target to fit the counter bore to alow laser alignment using the red spot laser / Lid open mode.
Push fit bearings now sit parallel after laser adjustment using the target
1184
161
Report Thing as Inappropriate
Tags
License
LaserBeamTarget by BodgeItQuick is licensed under the Creative Commons - Attribution - Share Alike license.
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.
Print Thing Tag
LaserBeamTarget by BodgeItQuick is licensed under the Creative Commons - Attribution - Share Alike license.
Download All Files
(4 kb zip file)
File Name
Downloads
Size
Comments
You must be logged in to post a comment.
