SD Card Holder Mark 2
25
Likes
714
Downloads
639
Views
Published on June 26, 2011
Description
This is a Mark 2 of the simple SD Card holder. This version still holds 8 cards but now the slots are a little bigger making it easier to get the cards in and out. Rather than using tight slots to keep the cards from falling out I have added a lid to this version which clips on nice and securely.
Instructions
Print the base and the lid. You will need to lightly sand the clips just to clean up a bit of the overhang.
If you have already printed the original cardholder then the lid fits on the old one if you use a soldering iron to melt a couple of indentations for the clip.
If you have already printed the original cardholder then the lid fits on the old one if you use a soldering iron to melt a couple of indentations for the clip.
You must be logged in to post a comment.
License
SD Card Holder Mark 2 by jpcw is licensed under the Attribution - Share Alike - Creative Commons license.
More from jpcw
I like the idea. I made one with 85% fill and let it cool.
The tabs on the lid broke before they flexed enough to clip onto the base.
Any suggestions?
Thanks for the design :)
BTW, I'm just using the default fill, 25% I think
Try sanding the tabs back a bit and it should be ok. You don't need them sticking out very far, just enough to catch in the hole.