by addy, published
My daughter loves narwhals. I promised to print her something on my ToM. This was a conversion from a sketchup file by Aerilius on google 3d warehouse. I scaled, split it in two. Seems to print well.
Added big nose version: The first one is 'anatomically' correct, the second one is a bit more printer friendly.
It printed well on 100% fill, 0 shells, 32mm feed rate on 3mm white abs using stepstruder mk6+, 1st half was ok, second half curled up a teensy bit on the tip of the horn, but that part is fine. Took 30 mins or so in total to print.
Smear acetone on one half, whack them together. Pick your teeth (or give to your daughter to make her happy).