AA Battery holder
78
Likes
853
Downloads
2021
Views
Published on July 2, 2011
Description
A battery holder that fits one AA battery, uses stripped wire as terminals. Use it in series, parallel or how you want.
The "CS" version is with two countersunk M3 mounting holes.
The "CS" version is with two countersunk M3 mounting holes.
Instructions
Prints good without any support on the UP! printer, in both solid and hollow option.
Good luck!
Good luck!
More from chris_e
More from Electronics
Can't seem to print this on my TOM
I don't know how experienced you are, so forgive me if this sounds obvious :)
Have you rotated and centred it?
[Rotate]-
&
gt;[X+], [Move]-
&
gt;[Center] then [Generate GCode] set extra shells to 0, print.