Cable Chain
73
Likes
1059
Downloads
1457
Views
Published on September 7, 2009
This thing was Featured on September 7, 2009
Description
Use this to guide your cables with.
Instructions
The red lines need to be cut, the blue lines need to be perforated so the can be folded.
I used 0.5 mm polypropeen to cut this from, as long as its a bit flexible
I used 0.5 mm polypropeen to cut this from, as long as its a bit flexible
You must be logged in to post a comment.
Anonymous
on
October 3, 2009
said:
If someone could manage to make a steel-rule die for this, they could be cranked out by the millions.
chris
on
September 9, 2009
said:
Great Idea, totaly could get some use out of this, hopefully, not sure i have the right material to make it, but im sure i can figure something out. 8-)
dmuren
on
September 9, 2009
said:
This is a very interesting design, especially since it can be easily cut by hand from heavy card, or light gauge plastic using a pen knife. Let's not forget, the original rapid-prototyper was a human with a knife :) I'd love to see more thingiversers paying attention to the hundreds of thousands of makers who have knives than to the hundreds who have makerbots. (Though, I admit, I am one of the latter :)
License
Cable Chain by Martijn is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from Martijn
This is brilliant. I don't have a use for it at the moment but I am downloading it anyway so I can have a play with it.
I will find some use for it. It looks great
I may modify the design slightly and try it with 3mm cold form acylic but that is a bit expensive so I will have to do a few tests first ;)
Mowcius