Spool Holder
23
Likes
677
Downloads
294
Views
Published on July 2, 2011
Description
This spool holder was designed so you could have one or add as many as you want. The top ring was designed to have the cyder inserted only half way in and then pined this allows for a second cyder to be put on the other side.
Instructions
print a top and bottom for each side you need then bolt them to each other.
Next print the cyder and pins. Insert cyder in to one ring then insert the square pin in top of ring. Place spool on cyder and then slide second ring on to cyder and then pin.
Next print the cyder and pins. Insert cyder in to one ring then insert the square pin in top of ring. Place spool on cyder and then slide second ring on to cyder and then pin.
You must be logged in to post a comment.
jballard
on
July 3, 2011
said:
why not use a piece of ABS or PVC Pipe for the round section? it would reduce print time and probably be even cheaper.
shack90
on
July 4, 2011
said:
I had thought about using PVC pipe but i thought way not just make the hole thing with the bot. plus it was going to be a week before i would be able to go to a hardware store to size pipe. But you are right it would be cheaper to us PVC. Maybe i will make a version that uses that instead.
License
More from shack90
The screw together T-supports are really cool. You could design an end table around them.