Quad legs and battery holder
by Drevious, published
These files are upgrades for the 5/16 (8mm) Rod Based MultiWii Quadcopter by Zarquon. The legs allow for easy changing and different heights make room for hanging items below the quad. There was never a battery holder for this quad so I built one (you will need two). The holes of the legs are designed to be slipped over the screws on the motor mounts without removing the screws. For the legs I used 25mm M3 screws. If you want "shocks" then use longer screws, 35-40mm and put springs between the legs and the motor mounts.
These files are designed in Geometric Design and are exported in mm. Print them as is and no support will be needed.
Liked ByView All
Give a Shout Out
Quad legs and battery holder by Drevious is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving Drevious a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Drevious would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).