Report as inappropriate

You are reporting ED3v6 PLA heat creep and what are your flow rates? as a violation of the Thingiverse Terms of Service.

I have read the Thingiverse Terms of service and I understand that falsely reporting violations can result in a ban from Thingiverse.

Thank you for taking the time to bring this matter to You are reporting ED3v6 PLA heat creep and what are your flow rates? as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

Description

Your Email Address

SteLeei - in reply to SteLeei

Nov 2, 2016

Thanks. The problem is not too fast extrusion, the hot end can push 15mm^3/s if I want it too. No, it´s rather a problem that occurs a lower flow rates. So there must be a problem with heat building up above the heat break, expanding the plastic. I´ll replace the PTFE tube with a fresh one today, and see if that helps.

Flag