check your tension on your extruder is tight enough pla is softer than abs so you need tighter tension... 200 to 210 is good for pla with a bed temp of 60 or no heated bed..
if clogs persist pull your hot end apart use a torch not a lighter lighter is a dirty flame a cigar torch etc works good heat it up and stick a super small oject you know wont break off in the hole to clear it out you might have to replace your teflon tube its cheap on ebay
check your tension on your extruder is tight enough pla is softer than abs so you need tighter tension... 200 to 210 is good for pla with a bed temp of 60 or no heated bed..
if clogs persist pull your hot end apart use a torch not a lighter lighter is a dirty flame a cigar torch etc works good heat it up and stick a super small oject you know wont break off in the hole to clear it out you might have to replace your teflon tube its cheap on ebay