The feet are a bit more snug than the rest, but they are split all the way so they flex open.
Mine measure 24.6-24.7
I would make a large calibration print to check that 100mm prints really close to 100mm X,Y, and Z, most don't check Z that is usually the worst one, then do a 100mm extrusion test to make sure you are not over extruding.
The feet are a bit more snug than the rest, but they are split all the way so they flex open.
Mine measure 24.6-24.7
I would make a large calibration print to check that 100mm prints really close to 100mm X,Y, and Z, most don't check Z that is usually the worst one, then do a 100mm extrusion test to make sure you are not over extruding.