Loading

Report as inappropriate

Printed on my Monoprice Select Mini sliced in Cura 2.3 with 0.2625 Layer Height and it turned out nice. The scissors and outside walls was fused together, and I broke and tore them up pretty good trying to get them separated, but the screw turned flawlessly. I'm guessing maybe my retractions settings maybe made too much blobbing on those close parts. Currently my settings are:

Retraction Distance 3.5mm
Retraction Speed 60mm/s
Retraction Minimum Travel: 0.8 mm

I'm wondering if I need to lower the retraction minimum travel to make sure to get retraction occurring between the outer walls and scissor arms.