Loading

Report as inappropriate

**Updated - The original method, doesnt disable the stepper motors for X and Y, so the extruder is not moving from its position. So once you click resume, it goes back where it was.
If you were to add a home X & Y will be pretty simple to this code. For example.
{REPLACE "\nM117 Layer 4, Z=" "\nG1 X10 Y5\nM0\nG1 X0 Y0\nM117 Layer 4, Z="}

On S3D u can either CTRL+P or click the icon on the right side. I have tested you can manually click feed E and it does, if you dont do it by hand. I have a bowden, so i feed it by hand softly until it primes. Should be same on direct drives.