No problem. As a n00b myself, I thought I was getting good prints and good print quality. But when I printed this part out it wouldnt fit together. I sanded, cut, and all that but it just wouldnt fit. Then I saw some of Tom's videos about calibration and how important it is. I got things setup to calibrate accurately as I could and it was a night and day difference. After I was calibrated and reprinted, everything went together rather nicely. The legs are perfect, the plate and bolt fit nicely. Sometimes you're lucky and get good prints out of the box. Other times you wont. You'll also need to calibrate often; filament is not consistent in size and when you're talking about a .1mm difference in size; it really does make a difference.