Loading

Report as inappropriate

I would highly suggest switching to a PEI build surface. No glue / no prep ever again, if you get the settings right prints pop right off with the correct amount of adhesion. Only suggestion is to do a couple test prints and start with the heat low then work your way up.

https://www.amazon.com/Gizmo-Dorks-Printing-Surface-Adhesive/dp/B01KGDTNQ2/ref=sr_1_3?ie=UTF8&qid=1487345949&sr=8-3&keywords=PEI

I've used this build surface on aluminium and borosilcate glass. All I do is wipe it off with rubbing alcohol and go again no mess.