Loading

Report as inappropriate

I'm using a sensor for bed leveling instead of the z-endstop...

But maybe another endstop setup can handle this issue, like this one: https://www.thingiverse.com/thing:1776429

Temporary for the next prints you might try to remove the lower of the two screws of the z-endstop and fixate it at a lower position with the remaining screw + tape/clamp/...

EDIT: Found this one some days later, which could also be usefull: http://www.thingiverse.com/thing:1610403

Z Endstop Fine Adjustment Prusa i3 - Anet A8
ANet A8 Z Endstop
by inteks