Report as Inappropriate

You are reporting a comment on Labyrinth Gift Box as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

I printed the outside cover at a slightly smaller size because I felt that there was too much room for moving through the maze and in some cases if the person just pulled hard enough it would just slide right over the grooves. I tried 2% smaller and that was too tight of a fit, I was not able to remove to lid once I got it to the bottom of the maze. I then went with 1% smaller and it works in my opinion very well, it is now much harder to just slide the lid over the grooves and off the capsule.

Great design and thank you