Loading

Report as inappropriate

Yes, the Z-endstop switch has been removed. The inductive sensor is now also doing endstop.
this can be configured in Marlin, this it what I have set Configuration.h

// The Z_MIN_PIN will then be used for both Z-homing and probing.
#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN

This sensor is wired to the same connector where the switch was.
the wiring uses a voltage divider
for wiring followed instructions from Thomas Sanladerer Video '3D printing guides: Setting up auto bed tramming leveling tilt compensation!' https://www.youtube.com/watch?v=EcGFLwj0pnA around 3:40
but remember his video is for a 12V printer, my Creality has a 24V supply, so the the voltage divider is different.

also remember as the probe is to the left, outside of the buildplate, I recommend that safe homing is enabled, otherwise you likely to crash the nozzle into heatbed.
In Marlin, Configuration have a look at this
( this will prevent Z homing when the Z probe is outside bed area)

#define Z_SAFE_HOMING