Loading

Report as inappropriate

Hi there,I just wanted to say that ,that design is really cool and I to be able to see the nozzle while printing is a big plus,I just wanted to ask as I'm very new to 3D printing and I've had my Anet A8 printer for about two months,and I've done quite a few prints like support frames and I wanted to upgrade to an E3DV6 hot end but I'm using a standard Anet auto level sensor that sits on the back of the X carriage and I'm not sure how to adjust the this X carriage to fit that,also how do I adjust the settings on skynet firmware for the E3DV6 Bowden set up and also settings on cura,I really apologise for troubling you and I'm really grateful for your help kind regards,Gareth Keith