Report as inappropriate

Very handy tool! I can cut the bevel OK by hand (had lots of practice) but I just started 3D printing and wanted to make something practical. I'm very glad I made this, it's so much faster and I get consistent results every time. Nice Job!

I saw one comment below that this took 40 minutes to print, mine took almost 7 hours on an Original Prusa i3 MK2. I used 30% infill density and minimal support. When I enter the suggested settings of 20% infill, .2mm resolution and no support into Cura, the estimate is still 2h 35m. I'm still really new to 3D printing so I am curious what settings others are using and how long your prints took. Thanks!