You are reporting QIDI TECH X-ONE FILAMENT SETTINGS as a violation of the Thingiverse Terms of Service.
I have read the Thingiverse Terms of service and I understand that falsely reporting violations can result in a ban from Thingiverse.
Thank you for taking the time to bring this matter to You are reporting QIDI TECH X-ONE FILAMENT SETTINGS as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.
Given: Filament type: PETG+ (Clear transparent) by T-Glase Taulman 1.75 mm. Model: TempTower_v2 Slicer: Cura 2.5.0 Quality: Layer Height: 0.15 Initial Layer Height: 0.5 Line Width: 0.4 Shell: Wall Thickness: 0.8 Top/Bottom Thickness: 0.8 Infill: Infill Density: 100% Infill Pattern: Lines Material: Printing Temperature: 240.0 Build Plate Temperature: 70 Diameter: 1.75 Flow: 100% Enable Retraction: Checked Retraction Distance: 1.5 mm Retraction Speed: 25 mm/s Speed: Print Speed: 40 Infill Speed: 80 Wall Speed: 20 Outer Wall Speed: 20 Inner Wall Speed: 40 Top/Bottom Speed: 15 Travel Speed: 120 Initial Layer Speed: 20 Initial Layer Print Speed: 20 Initial Layer Travel Speed: 60 Skirt / Brim Speed: 20 Cooling: Enable Print Cooling: Checked Support: Enable Support: Unchecked Build Plate Adhesion: Build Plate Adhesion Type: Brim Skirt / Brim Minimum Length: 0 Brim Width: 8 Brim Line Count: 20 Brim Only on Outside: Checked Dual Extrusion: Special Modes: Print Sequence: All at Once
Note: I would slow down the Speed down to 33% for the final top rendering if there are any signs of artifacting near the top.
Given: Filament type: PETG+ (Clear transparent) by T-Glase Taulman 1.75 mm.
Model: TempTower_v2
Slicer: Cura 2.5.0
Quality:
Layer Height: 0.15
Initial Layer Height: 0.5
Line Width: 0.4
Shell:
Wall Thickness: 0.8
Top/Bottom Thickness: 0.8
Infill:
Infill Density: 100%
Infill Pattern: Lines
Material:
Printing Temperature: 240.0
Build Plate Temperature: 70
Diameter: 1.75
Flow: 100%
Enable Retraction: Checked
Retraction Distance: 1.5 mm
Retraction Speed: 25 mm/s
Speed:
Print Speed: 40
Infill Speed: 80
Wall Speed: 20
Outer Wall Speed: 20
Inner Wall Speed: 40
Top/Bottom Speed: 15
Travel Speed: 120
Initial Layer Speed: 20
Initial Layer Print Speed: 20
Initial Layer Travel Speed: 60
Skirt / Brim Speed: 20
Cooling:
Enable Print Cooling: Checked
Support:
Enable Support: Unchecked
Build Plate Adhesion:
Build Plate Adhesion Type: Brim
Skirt / Brim Minimum Length: 0
Brim Width: 8
Brim Line Count: 20
Brim Only on Outside: Checked
Dual Extrusion:
Special Modes:
Print Sequence: All at Once
Note: I would slow down the Speed down to 33% for the final top rendering if there are any signs of artifacting near the top.