You are reporting Anet A8 Auto Leveling Sensor: TRONYX XY-08N as a violation of the Thingiverse Terms of Service.
I have read the Thingiverse Terms of service and I understand that falsely reporting violations can result in a ban from Thingiverse.
Thank you for taking the time to bring this matter to You are reporting Anet A8 Auto Leveling Sensor: TRONYX XY-08N as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.
I too have the Tronxy XY-08n. My fine tune Adjustment for mine is as follows on lines 589 through 591 in Configuration.h:
I have found that to be pretty much smack dab in the center for the sensor :)
I too have the Tronxy XY-08n. My fine tune Adjustment for mine is as follows on lines 589 through 591 in Configuration.h:
define X_PROBE_OFFSET_FROM_EXTRUDER -19 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER -46 // Y offset: -front +behind [the nozzle]
define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle]
I have found that to be pretty much smack dab in the center for the sensor :)