Report as Inappropriate

You are reporting a comment on Labyrinth Gift Box as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

Can you help? I have unsuccessfully attempted to make this piece 7 times now. Each time the pieces peel apart. I have increased the temp, still same issue. at one point in the middle of the lid printing, it slid off to the side. To begin with when I tried to slice it with repeter it gave me an error about being out of the print area. then in meshmixer, it says there is a gap in the image? Any ideas. I am using the Monopiece printer with 1.75mm PLA