Loading

Report as inappropriate

Thank you, I forgot about the zip ties as they were gone off my machine for over a year and did not realize it needed a work around.

As for the tower braces those could be printed on the top edge and would not require supports except for the threaded rod section.

While it does not visibly seem to support or show rigidity, its design was to be a clamping action when you threaded the bolt through the entire piece.

I have a version that is without levelers for those that need it to bolt to a flat surface. Just have not posted it yet.

Again thank you for your input and I will make a note for future endeavors.
For those that do not like the clamp method I will look at making a singular piece that uses less support.