Report as inappropriate

i printed the front at 20% infill the back i printed at 30% i think
rudder and motor mount i did 100% infill and abs
i had glued supports inside at the connection points
i hade yet to get the new 60A esc and i well upload a vid when its here :)

for now thou,
i have a 2440 4000KV motor and an nqd water jet that i wanna make in to a smaller jet boat

been looking around for another shazy to fit it but didnt find any so ... i was thinking making the shazy you made abit smaller
60% in the X and y axes and 50% at the Z access
what do you think?