Loading

Report as inappropriate

Ok so this thing so far is amazing looking, but I keep having an issue when it gets to the hilt of the sword and the wrist guard, just spaghetti mess everywhere. I've used supports off like an idiot, but also supports on and let's just say there's a wasted 10 hours of printing. HOW did you print this thing successfully? Is it possible for you to split the very top part off from the sword and I can just print it separate and glue it on? I would do it myself but I'm not sure what app to do it in.

This is what I've got after two full prints. https://i.imgur.com/ayHBpba.jpg (other one is down on the printer, failed in the same spot basically)
Thanks!