Loading

Report as inappropriate

OrionBG you might be printing too slow... it can also be a problem with the extrusion or just not a very good type of filament. I use Primaselect or any other premium PLA most of the time. Its really good at bridging. I have had problems with cheap PLA and pet-g on other models so i use some more expensive filament most of the time....

If i use 0.2 mm layer height i get 5 layers on top.
I think you get 3 layers if you go at 0.3 mm layer height. that might help...

these are my settings. I am using Simplify 3d.