Loading

Report as inappropriate

It bended a little bit on the bottom (like it "melted"), by the lack of proper supports directly underneath the first layers of the ball's outer shell; the plate is not directly under the ball, so there are no supports there unless I use supports everywhere, and even so it still did a poor job at supporting the ball and the result was the same. Your version with supports did great for the ball itself, but the plate supports got a bit too fused to the bottom of the tail segment, and removing them spoiled the smooth look of the scales underneath.

I'm so far still printing the first segment, until I get the formula right. I see that doing this kind of change might be a lot of work, so worry not, I'll play with the temperature and printing speed to get them to be just right ;-)