I'm trying to switch my extruder to E1 because the extruder overheats immediately when in E0. I've switched E0 and E1 in pins_RAMPS.h like I've seen in other forum posts, but that isn't working.
Do I have to change anything in configuration.h? What are all the steps to switching?
I'm currently using Jim Brown's Marlin config.
EDIT: I've used M302 S1 to test my stepper motor on E0 and that is working fine. It's the E0 heater cartridge port that has a short and always has voltage. New question: is there any way I can disconnect that E0 port? Bc now it's always putting out unneeded power.
I'm trying to switch my extruder to E1 because the extruder overheats immediately when in E0. I've switched E0 and E1 in pins_RAMPS.h like I've seen in other forum posts, but that isn't working.
Do I have to change anything in configuration.h? What are all the steps to switching?
I'm currently using Jim Brown's Marlin config.
EDIT: I've used M302 S1 to test my stepper motor on E0 and that is working fine. It's the E0 heater cartridge port that has a short and always has voltage. New question: is there any way I can disconnect that E0 port? Bc now it's always putting out unneeded power.