Loading

Report as inappropriate

I'm using this enclosure with Prusa MK2 for more than 1 year, I believe that's more than 1500 hours of print inside the enclosure, and I haven't got even one single problem with Y axis or the wire. If there WERE a problem, I'd just make 45°/60°/90° support for wires so they would go up behind the bed instead of horizontally out. Ofcourse you can also solder some silicon wire in between, which would cost 1,5$ - but again - there is no problem at all. You can also move printer LCD away completely and run it out and below the enclosure, which I already seen in one modification of my enclosure, and that also solves a "problem" completely.