I am not really sure if it can be scaled, moebious. You would need to scale the lattice frame, the tiles, and the top ring of the support frame by 85%. You would need to drill out the holes in the top ring to fit 1.5 mm dia. steel wire for the support frame. You would need to print the bottom ring of the support frame at its original size. I never tried this, so I cannot be sure if it would work. What is the size of your print bed? Most printers these days have a bed that is at least 200 mm square; the 196 mm dia. lattice frame should fit on such a bed without scaling. If your print bed is 200 mm square, you might have to shut off the skirt and/or brim function of your slicer to place it on the print bed in your slicer software.