Loading

Report as inappropriate

I had a similar experience on one of my printers, the FlyingBear P902. It has a 220 mm sq. print bed, but I was unable to place the 218 mm dia. lampshade in Cura. (I am still on 3.1.) However, I found that I had to turn off the skirt, and turn 'bed adhesion' to 'None'. (I had the skirt set to three millimeters away from the model; Cura would simply add 2 x skirt distance onto the 218 mm diameter of the lampshade, and conclude the model was too big. This is despite the fact that the bottom of the lampshade print is way smaller than 220 mm.)