Loading

Report as inappropriate

I did not print the interface hull as I could not figure out where it went and what it was for.

Does it go in the middle of the boat?

My printer has a max print size of 150mm x 150mm so I printed the...
hull_bow_129
hull_front_140
hull_middle_50
hull_back_140

I glued that all together. (See the attached file, is that correct?)

I then printed the...
motormount
rudder
rudder_mount
rudder_horn_4.3
servo_mount

I need to print the deck pieces but those will probably be last, I may need to trim them into three pieces or take the complete on and slice it in half to get under the 150mm requirement.

I haven't decided if I'm going to have a small prop that goes in the water or the larger propeller that is mounted above. I'm having trouble finding shafts for the small prop. I mean, I can find them, just, am not patient to wait for shipping from far away!

Also, this is a lot of fun, thanks for publishing this! My son and I are so excited to get this running and out on the water!