Loading

Report as inappropriate

I printed this for my sister.

Ziro Marble PLA

Layer Hight .2
Temp 200
Infil 15%
Print speed 50
No supports.

First time I printed it it broke loose about 80% done. Looked ok though up to that point.
Second finished. I did the second on a raft for better stick to the surface, and thinking it may give me a better finish on the spiral surface. I was wrong. It stuck fine but the appearance of the face is dissappointing. I might hit it with some filler and paint before sending it to her.

Underside of the the top having had no support was a little rough but is ok. Rest is ok but If I were to pint it again I would put more exterior shells or denser infil cause you can see the infil in the light. The marble effect is cool though.