Hi. I love this cable chain. I've been using it as a fidget toy while waiting for the rest to print. One thing that I noticed was that the PlateMountV2 does not have any space to use a cable tie to secure the bed cables to the OEM bed corner. The OEM bed corner does not have slots underneath like the the bed corner you designed. They are one the side. Your design for the Plate Mount actually uses the OEM slot that is designed for securing zip ties. I thought that I was going to need to drill out holes in the bottom of the OEM bed corner. But then I discovered that the fit on your Plate Mount is so tight, that it traps the cable even without a zip tie. I may add a little hot glue "bump" inside the plate mount to make it even tighter just for extra security. Thanks.