Loading

Report as inappropriate

Nicely done. I am going make a remix, from the STL, however, for the following:

  • The "baseplate" is very thin, and rather short, for a book end. If you remove the book nearest the end cap, everything will fall over. I am going to remove the base plate from the STL, which will allow it to be printed "face up", which will remove all supports and allow for ironing of the face.
  • I will add a separate plate, that attaches to the D&D end cap, with some snap ins. The plate will extend 4 inches from the end cap (I measure an existing bookend ;-) ), and include a some thicker lines, to strengthen it.

Thanks for designing this...I hope you like the mods.