Loading

Report as inappropriate

Hello Community, I have a problem.

First I printed and measured the jigs. Everything OK.

After that, I printed the version for the (original) V6 Hotend and it does not fit in the place where the top is put.

The opposite side (picture 5) fits well.

Then I looked at the step file and saw that the socket was designed exactly to measure.

Well, maybe I'm not so smart about 3d printing, but if I'm ok with outside dimensions, I have to construct inside dimensions always about + 0.4mm larger.

Likewise the holes for the M3 screws are constructed 3,1mm large and printed these are with me 2,7-2,8mm.

I hope you can make me a little smarter.