Report as inappropriate

Hy Ben. I was just testing the new almost ready printer,and i am used to Repetier Host and Slic3r on my other machines,do you have any special custom Gcode on the beginning of the code to use the mesh table? I cannot seem to make it work,at list i can not see the Z movement whe i am printing,and i have a bad mesh on my table.
Edit: And is there a way to compensate the skew? As i have made the calibration square and i am off by 0.9mm on a 300mm lenght of the table,at the moment i will try to play with the belt tension to see if i can compensate some more.