Loading

Report as inappropriate

If you have trouble getting noise out of this, try dipping it in cold water to help it harden up after the print. I had a few I thought were fails but a day later they worked, over two days they went from providing just a whistle to adding in a reverberation and extra volume as it cured. I was using PLA that came with the Flashforge Creator Pro. I used Simplify 3D to slice it and printed at 205. White PLA produced a louder sound right away so the ideal temp for blue must be a bit off from that. Very good results though. Impressive! I ran it at 50% infill on med quality. I had to use a raft but might try again without. My initial 10% infill let air out the sides...