Loading

Report as inappropriate

Hi Ben, I'm running into an issue - wondering if you've come across this same problem. When calibrating the Z height, I've noticed that the height I obtain from calibration doesn't seem high enough. I run through your calibration and come up with a difference of 0.725 - I'll add that to the config file, but when I try to print, the nozzle is still way to high, and nothing sticks. I have to add additional height - ex. change to 0.900 in order to adequately squish the first layer to the bed... It's quite frustrating due to the amount of trial and error required. I was wondering if you had any suggestions?